Filter
Top Products
12 en | Configuration through the Web Interface DSDA iSCSI Disk Array Series
V 1 | 2008.08 Installation Guide Bosch Security Systems
19. The changes are summarized on the Commit screen.
Click Commit to apply the new settings.
5.3 Configuring the Volume
The system is preconfigured with one volume that contains either two or three hard disks. You
need to add the remaining disks of your system to the volume in order to use their capacity.
20. In the navigation panel, select Volumes > Manage.
The preconfigured volume, named vol0, is listed.
21. Click vol0 to display and change the properties of the volume.
22. Click Add Disks. This starts a wizard for adding disks to the existing volume.
23. Click Next on the welcome screen of the Volume Wizard.
24. Disk Selection: Check Automatic. Click Next.
25. Disk Size: Select Any Size. Click Next.
26. Number of Disks:
– DSA-S5B50: Select the maximum number of disks available from the list. Click Next.
– DSA-N2B20 / DSA-N2B50, no extension shelves: Select the maximum number of
disks available from the list. Click Next.
– DSA-N2B20 with extension shelves: Add 9 disks. Later on, create further volumes as
described in Section 6.1.4 Adding New Volumes, page 19.
Click Next.
– DSA-N2B50 with extension shelves: Add 17 disks. Later on, create further volumes as
described in Section 6.1.4 Adding New Volumes, page 19.
Click Next.
i
NOTICE!
If you are using the VRM Video Recording Manager application (Version 1.5 or higher), all
further settings are made through VRM.
If you use the digital storage systems for direct recording, continue with the following steps.