Filter
Top Products
24 en | Area settings IVMD | Configuration instructions
1.0 | 2006.04 BOSCH Security Systems
The calibration mode also provides a context menu with the fol-
lowing commands:
Anchor point
Corner of a cube
The size of both cubes changes – both
cubes always represent the same size.
Line of a cube The cube can be positioned as desired.
Save and Exit
Calibration
The settings are saved. You leave the cali-
bration mode.
Cancel Calibration You leave the calibration mode without
saving the settings.
Reset You stay in calibration mode; all settings
are reset to their original status.
Center Cubes Both cubes are positioned centrally on
the calibration plane.
Settings Shows the calibration settings.
You can change the settings by entering
values. This is described in the next sec-
tion.