Filter
Top Products
IVMD | Configuration instructions Area settings | en 23
BOSCH Security Systems 1.0 | 2006.04
4.3.1 Adjusting the calibration plane
This section provides an overview of the ways in which the cali-
bration plane can be adjusted. Move the mouse cursor over an
anchor point or a line and then perform the required action
while holding down the left mouse button.
Start position At the beginning, the calibration plane
is shown upright.
Anchor point
Center of a side line of
the plane
The calibration plane is scaled.
Anchor point
Center of the plane
The entire calibration plane is moved.
One of the lines of the
plane that is horizontal
in the start position
The calibration plane is tilted horizon-
tally; the tilt angle is changed. Refer to
the description of the settings on
page 26.
One of the lines of the
plane that is vertical in
the start position
The calibration plane is tilted vertically;
the roll angle is changed. Refer to the
description of the settings on page 26.
Anchor point
Corner of the plane
The calibration plane is rotated.