Filter
Top Products
F220 Series Detectors with F220-B6/C/E/R Bases General Information | en 3
Bosch Security Systems, Inc. Installation Manual 4998138694 -04 | 2007.01
use a can of clean, dry compressed air (such as TECHSPRAY
ENVI-RO-TECH Duster) which is available at office and alarm
supply stores. Shorten the plastic tube that comes with the
compressed air to about 2 in. (5 cm). Place the tube or needle
valve through the Chambermaid valve in the bottom of the
detector (refer to Figure 2.2 on page 7).
2 General Information
This document covers mounting, wiring, power requirements,
testing, and maintenance for the F220-B6, F220-B6C, F220-B6E,
and F220-B6R Detector Bases and the F220 Series Heat and
Photoelectric Smoke Detectors. Install them according to
NFPA 72.
For installation guidelines, refer to Installation Considerations
for Smoke and Fire Detectors (P/N: 26715).
2.1 F220-B6 Series Detector Bases
2.1.1 Compatible Control Panels
Two-wire:
i
NOTE! Do not paint the detectors. Paint or other foreign
matter covering the detector can prevent smoke
detection.
i
NOTE! For proper system installation, read and
understand NFPA-72 before installation.
i
NOTE! Bosch Security Systems, Inc. makes no claim
written, oral, or implied that the F220 Series Detectors
work with any two-wire control panels except those
specified in the Base Compatibility chart in Technical
Service Note (P/N: 4998148185).
4998138694Er7.book Page 3 Thursday, March 1, 2007 8:42 AM