Filter
Top Products
RAID Subsystem DVA-16K | Installation Manual Hardware Installation | en 21
Bosch Security System F.01U.027.799 | V2 | 2008.08
3.4 General Installation Procedure
Following all the instructions provided below can save subsystem installation time. Detailed,
illustrated instructions for each component are given in the following sections.
1. Unpack: Unpack the subsystem and confirm that all the components on the packing list
have been included. (See Section 3.5 Unpacking the Subsystem)
2. Rack/Cabinet installation: If the subsystem is going to be installed in a rack or cabinet, it
should be installed prior to installing the hard drives. Installing the subsystem into a rack
or cabinet requires at least two (2) people. (See Section 3.6 Rack/Cabinet Installation)
3. Install drive trays: After the hard drives have been installed into the drive trays, the drive
trays must be installed into the enclosure itself. (See Section 3.7 Drive Tray Installation)
4. Cable connection: Use the power cables to connect the subsystem to the main power
source. Use the SCSI cable to connect a host port to the host computer or an external
device.
5. Power up: Once the components have been properly installed and all cables are properly
connected, you can power up the subsystem and configure the RAID array. (See
Section 5.4 Power On)
3.4.1 Installation Procedure Flowchart
Table 3.1 shows a flowchart of the installation procedure. As you complete each step, check
the “Done” box on the right. Please use this flowchart in conjunction with the instructions
that follow.
3.5 Unpacking the Subsystem
Use the Unpacking Checklist in your package to verify package contents. Carefully check the
items contained in each box before proceeding with installation.
CAUTION!
To ensure that your system is correctly installed, please follow the steps outlined below. If you
follow these steps, installation will be fast and efficient. If you do not follow these steps, you
may accidentally install the hardware incorrectly.
Step Installation Procedure Done
1 Unpack See Section 3.5 Unpacking the Subsystem
3 Rack/Cabinet Installation See Section 3.6 Rack/Cabinet Installation
5 Drive Tray Installation See Section 3.7 Drive Tray Installation
6 Cable Connection
7 Power On See Section 5.4 Power On
Table 3.1 Installation Procedure Flowchart
i
NOTICE!
A detailed packing list can be found in your product shipping package or product CD.