Filter
Top Products
DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 8
Bosch Security Systems | 6/05 | 4998154961B
6.1.2 Perimeter Instant Arming
Use perimeter instant arming to arm only the exterior (perimeter) zones when you remain in the building. An exit
delay is in effect, but no entry delay is in effect so an alarm does occur upon entry.
The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green
LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section
6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).
Table 4: Perimeter Instant Arming
Equipment Command Sequence What Happens What To Do
Text Keypad LED
Keypad
[PIN][No Entry]
[Perimeter Only]
• The red Armed LED flashes.
• “Perimeter Inst.” is displayed. *
• “Exit Now” is displayed during exit-delay. *
• The green Status LED lights steady.
• A single beep sounds.
• The red Armed LED lights steady when
the exit-delay period ends.
• The yellow Perimeter LED lights steady. **
• Only exterior protection zones are armed.
• Move freely around the
interior.
• Opening any exterior
door or window triggers
an alarm.
RF3341 Keypad [PIN][#][2] • The LED flashes indicating a signal was
sent to your security system.
• Only exterior protection zones are armed.
• Move freely around the
interior.
• Opening any exterior
door or window triggers
an alarm.
RF3332/RF3332E,
RF3334/RF3334E
Not applicable
* Text Keypad only
** LED Keypad only