Filter
Top Products
DS7400XiV4-EXP | User Guide | 11.0 The Master Keypad (Text Keypad Only) EN | 31
Bosch Security Systems | 6/05 | 4998154961B
11.0 The Master Keypad (Text Keypad Only)
11.1 General Information
Your system can include a Master Keypad. A Master Keypad is a text keypad programmed to provide access to
all areas assigned to you, not just the area in which the Master Keypad is located. This is different from a standard
keypad because standard keypads provide access only to the single area in which they are located. Commands
entered at the Master Keypad affect all the areas to which you have access. If this is not desirable, the Master
Keypad can control each area individually using Single Partition Mode. Single Partition Mode allows you to
control any or all of the areas to which you have access on an individual (one by one) basis (refer to Section 11.3
Single Partition Mode).
To use the Master Keypad, your PIN must be assigned to the area in which the Master Keypad is
located.
11.2 Master Keypad Displays
Master keypad displays differ slightly from standard keypads. The Master Keypad display scrolls the status of each
area, followed by the area number. For example, if all areas are armed, the Master Keypad scrolls through the
following displays:
Armed
area 1
Armed
area 2
Armed
area 3
Armed
area 4
Armed
area 5
Armed
area 6
Armed
area 7
Armed
area 8
If only areas 1, 2, 3, 4, 6, and 8 are armed, the Master Keypad scrolls through the following displays:
Armed
area 1
Armed
area 2
Armed
area 3
Armed
area 4
Ready to
Arm area 5
Armed
area 6
Ready to
Arm area 7
Armed
area 8
Areas that are not ready display as “Not Ready.”
Table 30 helps you understand what each LED function of the Master keypad represents.
Table 30: Master Keypad LEDs
LED Off Flashing On
Armed
(red)
All areas are disarmed. One or more areas are armed, or
an alarm occurred.
All areas are armed, and no alarms
occurred.
Status
(green)
Not ready to arm (if the Armed LED
is on, all areas are armed).
One or more zones are
bypassed.
All areas are ready to arm.
Power
(green)
The control panel lost all power; no
AC or battery.
Control panel problems exist.
Refer to Section 9.0 Error
Displays on page 25.
Normal Operation. The control panel is
running on AC power with no problem.
Fire
(red)
There are no fire alarms. A fire zone is in alarm. A fire trouble condition exists.