Filter
Top Products
D1260/D1260B | Owner's Manual | Part III: Advanced Commands - DOOR CONTROL (COMMAND + 4 + 6)
42 Bosch Security Systems | 9/04 | 50410D
Cycle Door
1. If you wish to momentarily unlock an access door
to allow a person into an area, press the
Cycle
Door>
soft key.
2. The display will read *
Cycle Door*1 2 3 4 5 6 7 8
if all door are at a normal state and are available.
If a door is not at a normal state, the number of the
door would be replaced with a symbol indicated in
Table 3.
Table 3: Door Status
Symbol Meaning
- Door is not active, in scope, or user does not
have access level authority.
C Door is on timed door sequence.
U Strike and shunt are latched active (held
open).
X Strike and shunt are deactivated (secured).
F There is a problem with the door. Call your
security company.
3. Enter the number of the door you wish to cycle
then press the ENTER key. This door will be
cycled and the display will change to reflect the
new status of the doors.
For example, if you wanted to cycle Door 3, press
3
then press the ENTER key.
The display changes to show that all the doors are
at a normal state except for Door 3, which is
cycled.
4. Enter another door number to cycle or press the
Exit>
soft key to leave this function.
Unlock Door
1. If you wish to unlock an access door to allow free
access, press the
Unlock Door>
soft key.
2. The display will read *
Unlock Door*1 2 3 4 5 6 7
8
if all door are at a normal state and are available.
If a door is not at a normal state, the number of the
door would be replaced with a symbol indicated in
Table 3.
3. Enter the number of the door you wish to unlock
then press the ENTER key. This door will be
unlocked and the display will change to reflect the
new status of the doors.
For example, if you wanted to unlock Door 3,
press
3
then press the ENTER key.
The display changes to show that all the doors are
at a normal state except for Door 3, which is
unlocked.
4. Enter another door number to unlock or press the
Exit>
soft key to leave this function.
Secure Door
1. If you wish to unlock an access door to allow free
access, press the
Unlock Door>
soft key.
2. The display will read *
Secure Door*1 2 3 4 5 6 7
8
if all door are at a normal state and are available.
If a door is not at a normal state, the number of the
door would be replaced with a symbol indicated in
Table 3 on page 42.
3. Enter the number of the door you wish to secure
then press the ENTER key. This door will be
secured and the display will change to reflect the
new status of the doors.