Bosch Appliances D1260B Home Security System User Manual


 
D1260/D1260B | Owner's Manual | Part II: System Commands - Turning On the System (Arming)
16 Bosch Security Systems | 9/04 | 50410D
Turning On the System (Arming)
Your security system can be turned on (armed) in
many different ways, depending on the arming
command used. Arming Commands are those
commands used to turn on the system. The most basic
arming command is to arm the entire system. The
simplest way to arm your system is to enter your
personal passcode or press [COMMAND] [1].
There are several other arming commands to turn on
the system. These are described later in this manual.
To Turn Your Security System On (Arm):
1. Enter your passcode and press ENTER.
2. The keypad briefly displays
AREA 1 NAME
TEXT is now arming…
,
and the exit delay tone begins. After exit delay
time expires,
the display changes to idle armed text.
Turning Off the System (Disarming)
Entering your personal passcode turns off your security
system. When the system is turned on, you must enter
through a designated entry door to prevent an instant
alarm condition. Opening the door starts entry delay
time and the Keypad emits a pulsing “beep” tone to
remind you to turn off the system. Enter your passcode
before the delay time expires and the system will turn
off.
If you enter through the wrong door or fail to disarm
before the entry delay time expires, you will cause an
alarm.
If this happens, silence the alarm (by entering your
personal passcode and pressing ENTER) and call your
security company to let them know that it is not an
emergency situation.
To Turn Your Security System Off (Disarm):
1. Enter your passcode and press ENTER.
5. You must press the ENTER key within 5 seconds
of entering your passcode, or the passcode entry
will be invalid.
6. The display returns to idle disarmed text.
Turning On the System (Arming) With a
Duress Passcode
Your passcode may have a special duress feature that is
simply your personal passcode with its last digit
increased by 1 or 2.
If an intruder demands that you arm or disarm the
security system, you can use your duress passcode. The
duress passcode arms or disarms the system
and
sends
an alarm report to your security company. There is no
alarm tone or visual indication at the premises that the
report is sent. Check with your security company
before attempting to use this feature.