Filter
Top Products
Installation and Operating Manual | VideoJet 8008 / VideoJet 8004
EN | 18
Installation Bosch Security Systems | 2006-07 | V1.5
Installing in a switch cabinet
VideoJet 8008 and VideoJet 8004 are set up for installation in a 19-inch rack.
The necessary mounting kit is already supplied.
Caution
When installing in a switch cabinet, ensure that there is sufficient ventilation
for each unit: There must be at least 5 cm (1.97 in.) of free space to the left
and right of the unit and at least 10 cm (3.94 in.) at the rear.
The ambient temperature must be between 0 and +40 °C
(+32 and +104 °F), and the relative humidity must not exceed 80%.
The unit heats up during operation, so you should ensure that there is
enough clearance between the unit and other heat-sensitive equipment or
objects.
When mounting additional units, direct contact is permitted, provided that
the surface temperature of the adjacent units does not exceed +40 °C
(+104 °F).
Installing the unit
– On the left and right-hand sides of the housing, loosen the two screws on
the front panel and remove them completely.
– Insert the two angle brackets from the mounting kit into the slots next to the
screw holes on the housing and secure them with the four housing screws.
– Set the unit in the switch cabinet frame and secure the angle brackets using
the four screws, washers and lock nuts provided.
– Connect the rubber connector of the power cable supplied to the
Power socket on the rear panel of the unit.