Filter
Top Products
– 10 –
LIMITED WARRANTY
This warranty covers “Bock” Water Heater models 20e, 20pp, 32E, 32EC, 32PP,
32PPC, 33E, 33PP, 40E, 40PP, 50ES, 50ESC, 51E, 51EC, 51PP, 51PPC, 71E
and 120E. Bock Water Heaters, Inc., a division of Bock Corporation–a Wisconsin
corporation–at 110 South Dickinson Street, Madison, WI 53703 (“Company”),
warrants to the owner, the tank of this water heater will not leak due to defective
materials or workmanship for FIVE years from the date of original installation. If
the water heater is installed in other than a single family dwelling, this warranty is
limited to THREE years from the date of original installation. The company also
warrants that no other part of this water heater will fail due to a defect in material
or workmanship for one year.
The company’s responsibility is to repair or replace, at our option with the pre-
vailing comparable Bock model, any part of the equipment sold by the Company
which proves to be defective in material or workmanship, including the tank,
during the warranty period when installed in accordance with applicable codes
and ordinances, and operated and maintained in accordance with our instruc-
tions, subject to the conditions and exceptions indicated below
. Our liability, in the
event of leakage or other malfunction, is strictly limited to repair or replacement of
the defective heater or part, as provided herein. We are not responsible hereun-
der for incidental property damage or personal injury, consequential costs or
damage. Equipment that is repaired or replaced will carry the unexpired portion
of the original equipment warranty.
Any burner and/or controls used on a Bock water heater other than the ones rec-
ommended by Bock Water Heaters Inc., and listed by Underwriters Laboratories,
Inc., will void the warranty.
Bock W
ater Heaters, Inc. specifies burners and controls on the basis of safety
,
reliability and performance. Only the following burners and controls have been
tested and approved by Bock Water Heaters, Inc. and Underwriters Laboratories,
Inc., to meet the stringent standards required by both.
(Refer to chart A, page
11).
Honeywell L4103A
combination aquastat and high limit controller. One well is
needed. Part #138134E. (See figure 7).
White Rodgers 11C30-11 combination aquastat and high limit controller. One
well is needed. Part #F89-0214.
Carlin EZ-Temp 90000B — Part #21585. One well is needed — Part #21587.
(See Figure 5, 6).
Honeywell L4006A (aquastat) and L4080B (limit control). Two wells are need-
ed. Part #123871B.
Not to be used on 32E series.
(See Figure 8).
Carlin EZ-T
emp 90000C — Part #
21582
.
T
wo wells are needed — Part
#21587
. (See Figure 5, 6).
Carlin EZ-Temp 90300B — Part #21589
. Two wells are needed — Part
#21587. (See Figure 5, 6)
At the company’
s request, the owner is to return to the factory at Madison, WI,
any part, including the tank, defective in material or workmanship, and pay all
transportation charges for such return parts and for replacement parts sent
from the factory to the owner
.
20e, 32E, 33E, 40E, 51E, 71E
residential applications:
WARRANTY
COVERAGE
COMPANY’S
RESPONSIBILITY
BURNER
& CONTROLS
50ES, 120E &
commercial
applications:
OWNER’S
RESPONSIBILITY