Filter
Top Products
www.bissell.com 800.237.7691
Operations
8
Power cord storage
When you have finished using your
BISSELL CleanView Helix, return it
to the upright position and store the
power cord.
1. Turn vacuum cleaner off.
2. Unplug power cord by grasping the
polarized plug (NOT the cord) and dis-
connect from outlet.
3. Loop power cord around cord wraps on
side of vacuum cleaner.
4. Clip molded plug to power cord to secure.
To maintain maximum cleaning per-
formance, the following maintenance
steps must be performed:
1. Empty the dirt container when the dirt
reaches the “Full” line on the side.
2. Check the inner and outer circular filters
and the pre-motor filter at least once a
month and clean or replace as needed.
3. Replace the post-motor filter every three to
six months.
Note: More frequent filter clean-
ing or replacing may be necessary
if you are vacuuming new carpet,
fine dust, or have allergy concerns.
Follow the instructions on the fol-
lowing pages to perform these
simple maintenance steps.
Empty Dirt Container
The dirt container needs to be emptied
when the dirt reaches the “Full” line on
the side of the container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock 'n Seal
™
lever to the
"Unlock" position.
3. Grasp dirt cup portion handle and pull
straight out to remove from vacuum.
4. Empty dirt into garbage container.
NOTICE:
While vacuuming, certain carpets
and low humidity conditions may
generate small static discharges. The
discharges are entirely harmless and
are not associated in any way with
the main power supply.
Tip:
For maximum cleaning
performance, check
and clean or replace
all filters as suggested.
WARNING:
To reduce the risk of electric
shock, turn power switch OFF
and disconnect polarized plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
Full Line
Lock Position
Unlock Position
2.
Maintenance and care