Filter
Top Products
www.bissell.com 800.237.7691
11
Maintenance and care
.
5. Clean strings, hair and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Clean strings, hair and other debris
from motor pulley and drive belt
areas.
7. Check drive belt carefully for wear,
cuts or stressed areas.
8. Check air passageway for obstruc-
tions. Remove debris from this area.
Replace drive belt
Use only genuine BISSELL style 9
replacement belts (#32074) in your
BISSELL CleanView Helix.
1. Unplug cleaner from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of Check
rotating floor brush and drive belt),
grasp old drive belt and remove from
motor pulley. Discard old drive belt.
3. Place new drive belt over motor pulley
and stretch other end over rotating
floor brush in the space between the
bristles.
4. Place ends of rotating floor brush
down into slots on sides as shown.
5. Turn rotating floor brush by hand
several times in the direction of motor
pulley. If properly installed, drive belt
will center itself on rotating brush.
6. Reposition brush cover and screw
back into place.
Air Passageway
Motor
Pulley
8.
4.
Checking rotating floor brush and drive belt continued