Filter
Top Products
Your ProHeat 2X comes in three, easy to
assemble components:
Upper Handle
Lower Handle
Tool Caddy
The only thing you will need to assemble your
cleaner is a Phillips head screwdriver.
1.
Slide upper handle onto lower handle.
2
. Screw 3 screws into the marked holes.
3.
Place upper hose rack onto back of upper
handle, and secure with screw.
4.
Place lower hose rack onto back of upper
handle by pushing in and sliding down until
it snaps into place.
5.
Snap tools into the tool caddy as shown in
figure 5.
6.
Wrap power cord and flex hose as shown in
figure 5.
7.
Keep flex hose snugly in place by using
the hose secure latch.
ProHeat 2X assembly is now complete.
Assembly
6
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
WARNING:
Do not plug in your
cleaner until you have
completely assembled it per
the following instructions
and are familiar with all
instructions and operating
procedures.
Tough
Stain Brush
TurboBrush
(select models)
Spraying
Crevice Tool
(select models)
Crevice Tool
Holder
(select models)
Hose Secure
Latch
1. 2.
3. 4.
5.
6.