Filter
Top Products
Troubleshooting
Cleaner not picking up solution
Possible Causes Remedies
1. ReadyTools dial may be at wrong setting. 1. Set ReadyTools dial to either
FLOOR CLEANING or TOOLS
setting.
2. Tank may not be seated properly. 2. Pick up both the 2-in-1 water
tank and formula tank and
reseat them so they fit snugly on
the unit.
3. Tank may not be assembled properly. 3. Check to make sure the "lip" of
the nozzle is securely hooked
into the groove on bottom of
Tank (see page 9).
4. Solution or 2-in-1 water tank is empty. 4. Check fluid levels in heavy duty
bladder and formula tank.
5. 2-in-1 water tank has picked up 5. Empty 2-in-1 water tank. Refill
maximum dirty water and red float heavy duty bladder with clean
door has closed. hot tap water and replace.
6. Red float "door" in the tank may have closed 6. Turn the machine OFF ( O ),
as a result of bumping an object or moving allowing red float door to release into
machine back and forth too quickly. the open position. Turn unit back
ON ( I ) to continue cleaning. Be
sure your forward and backward
strokes are done at a slower pace.
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of service.
Contact us directly at 1-800-237-7691.
20
w ww.b is se ll .c om 8 00 .2 37 .7 69 1