Filter
Top Products
Operation
Cleaning with attachments (Continued)
4. Set custom clean dial for heavy traffic, normal
clean, light clean, or water rinse as desired.
5. Attach the cleaning tool to the end of the hose.
6. Plug in and turn on the power switch and
heater (if desired).
7. Clean by pressing the trigger to spray solution
onto the area to be cleaned. Slowly move the
tool back and forth over the soiled surface.
Release the trigger to suction soiled water.
Continue to clean in the area, working in small
sections, until no more dirt can be removed.
Rinse (optional) and suction as needed.
Caution: Do no overwet.
8. Remove and rinse tools in clean, running
water. Dry and replace in the tool caddy.
9. It is recommended that you suction clean
water from a bowl to rinse out the hose.
10. Before replacing lift end of hose and stretch
out to ensure all water is cleared from hose.
11. Coil flex hose around the tool caddy.
12. Empty 2-in-1 water tank and rinse out,
following the instructions on page 11.
13. Return ReadyTools dial to floor setting.
13
w ww.b is se ll .c om 8 00 .2 37 .7 69 1
5.
9. 10.