Filter
Top Products
Before you clean
1. If desired, move furniture to another area if
cleaning an entire room.
2. Vacuum area with a dry vacuum cleaner
before cleaning.
3. Plan your cleaning route to leave an exit
path. It is best to begin cleaning the corner
farthest from your exit.
Fill the clean water/formula tank
1. Remove the clean water/formula tank from the
base of the machine by pulling up and out from
the back. You can also detent the handle and
pull the tank straight up if you desire.
2. Unscrew the black cap and red insert. Remove
and set aside.
3. Fill the tank up to the FILL LINE with hand
hot tap water.
4. Add 3 ounces of formula (always use
genuine BISSELL formulas to maximize
cleaning and for the safety of your machine).
5. Replace the cap and insert and tighten by
turning clockwise.
6. Replace the clean water/formula tank back
into the machine. Be sure that the cap is
seated in the receiver.
Carpet washing
1. Make sure the ReadyTools Dial is in the
FLOOR CLEANING position.
2. Plug the ReadyDry into the proper outlet and
turn the power on using the switch in the
back.
3. With your foot, press the gray handle release
lever located on the back of the unit. Take
care to notice the way the machine floats
forward.
4. While pressing the spray trigger make one
forward wet pass and another one back.
Repeat once and move on to the next
section of carpet or area rug to be washed.
Take care not to run over loose objects of
the edges of area rugs.
7
www.bissell.com
2
4'
3'
1
3
4
5
6
7
9
10
11
12
EXIT
START
HERE
Operation
Tip: Thorough vacuuming
before carpet washing will prevent
early clogging of the lint screen.