Filter
Top Products
10
www.bissell.com
Oxy Gen2™ PowerTool
To use the Oxy Gen2 PowerTool:
1. Pull out the rubber stopper in the tank.
2. Fill with Oxy Gen2
™
formula.
3. Replace the rubber stopper and attach the
tool to the hose grip.
4. Refer to page 9 “ReadyTools” steps 9-10.
Machine care
For best results, a few simple steps can assure
your carpet washer is well maintained after your
cleaning is complete.
1. Turn power switch off. Unplug the machine
and wrap the power cord.
2. After emptying the dirty water tank, rinse it
with running hand hot tap water, taking care
to clean all around the interior.
3. If necessary, check and clean out the lint screen
after each use by wiping clean any visible residue.
4. Replace the dirty water tank back into the machine.
5. Any loose hair or debris can be pulled from
the PowerRoller and thrown away.
6. To clean the attachments, remove from hose
and rinse in clean, running water. Dry before
storing. Clean the hose by suctioning clean
water from the tap. Before wrapping back on
machine, lift end of hose and stretch out to
ensure all water is cleared from hose.
7. Wipe the machine’s exterior with a soft cloth.
8. Machine Storage: Allow PowerRoller to dry
completely before storing. Put the unit away
in a closet or basement for the next use.
Store in a protected, dry area. Since this
product uses water, it must not be stored
where there is a danger of freezing. Freezing
will damage internal components and void
the warranty.
Operation
Maintenance and care
Lint Screen
Rubber Stopper