Filter
Top Products
w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
11
Maintenance and care
Cleaning the pre-motor filter
The pre-motor filter protects the
motor from dirt and dust par-
ticles.
1. Unplug the vacuum from electrical
outlet.
2. Disconnect hose
3. Open the dust bag compartment by
lifting up on the latch on the door at
the front of the vacuum. Lift out the
dust bag holder and dust bag.
4. Remove the filter frame from the filter
holder by grasping the lip of the
frame and pulling up.
5. Remove the filter from the filter frame
and clean by hand washing in
warm water. A mild detergent can
be used if desired. Allow the filter to
air dry thoroughly before replacing.
6. Place the filter back into the filter frame
and replace back into the filter holder.
NOTE: The filter frame should
be placed so the protective
frame is visible.
7. Place dust bag holder and dust bag
into the dust bag compartment, mak-
ing sure the entire bag is tucked in
below the seal gasket.
8. Close dust bag compartment door
and press down gently until it locks
into place.
9. Reconnect hose.
Washable Pre-
Motor Filter
NOTICE:
This product is intended for household
use only and not for commercial or
industrial use. Vacuuming of dust
from products like plaster, concrete
or ashes will damage the motor and
void the warranty.
Tip:
For maximum cleaning perfor-
mance, check the filters often and
clean or replace if necessary.
WARNING:
Do not operate cleaner with
damp or wet filters or without
all filters in place.
3.