Bissell 6596 Vacuum Cleaner User Manual


 
Place the TurboBrush in the Bracket by aligning the
bottom of bracket with the opening of the brush roll
and snap the TurboBrush into place.
Press the Handle Release Pedal with your foot to place
your vacuum in one of three cleaning positions.
Upright- For storage and above floor cleaning with tools.
Normal Cleaning- Press Handle Release Pedal once.
Use for most household floor cleaning tasks.
Low Cleaning- With the vacuum in normal cleaning position,
press Handle Release Pedal again. Use for reaching under
low furniture such as tables, chairs or beds.
The Powerfoot/Rotating Floor Brush can be
adjusted to clean several floor surfaces.
NOTE: For optimal cleaning performance,
adjust to the lowest practical setting. If
your cleaner is difficult to push, adjust to
the next higher setting.
Place Handle in Upright Position.
Turn Height Adjustment Knob to desired setting.
Lowest Setting For bare floors.
Medium Settings For short and medium
pile carpets.
Highest Setting For plush pile carpet.
Place the Handle in the normal cleaning position and
the Powerfoot will adjust to the setting chosen.
NOTE: You may also adjust the setting
while in the normal cleaning position.
To move your cleaner from room to room, put the
Handle in the upright position, tilt the cleaner back on
its rear wheels and push forward.
The cleaner can also be moved by using the Carrying
Handle on the back.
Attach Vacuum Hose and Tools Continued
6
1.
2.
3.
Height Adjustment
How To Use Your Vacuum
Handle Positions
1.
2.
3.
CAUTION:
Before using your vacuum,
make sure that the Dirt
Container is in locked
position and that all filters
(Inner Circular, Outer Circular,
Pre-Motor and Post-Motor) are
in place. Do not operate your
vacuum without these filters.
Tip:
Your vacuum features
a Quick Release Cord
Wrap. To remove the
Power Cord quickly
and easily, rotate the
Upper Cord Wrap
towards floor, and
slip Power Cord from
Upper and Lower
Cord Wraps.
Tip:
Before cleaning under
low furniture, check
area first for objects
that might harm the
unit or block the
Vacuum Hose.
5
Carrying Handle
7.
Transporting Cleaner
1.
2.
ug203-2829_6596_1105.indd 6ug203-2829_6596_1105.indd 6 1/11/06 4:03:36 PM1/11/06 4:03:36 PM