Filter
Top Products
Tools won't pick up dirt, continued
Possible Cause Remedies
Dirt Container full Empty Dirt Container
Dirt Container or Upper Tank Position correctly and
not installed properly lock in place
Filters are dirty Check and clean Inner and Outer
Circular Filters and Pre-Motor Filters.
Replace HEPA Post-Motor Filter
Louver missing or installed incorrectly Check for a clog in the tube in the
center of the Dirt Container, clear
and properly install Louvers
Vacuum cleaner is difficult to push
Possible Causes Remedies
Incorrect Height Adjustment Adjust Powerfoot to correct
height setting
Brush Cover installed incorrectly Make sure all three latches
are secured
Visible dirt escaping from cleaner
Possible Causes Remedies
Dirt Container full Empty Dirt Container
Filters missing or installed incorrectly Check Inner and Outer Circular
Filters and HEPA Post-Motor Filter
for correct installation
Dirt Container installed incorrectly Pull out and re-insert Dirt
Container correctly
Filter Cup installed incorrectly Remove Dirt Container and make
sure Filter Cup is fully attached
If suggested solutions do not correct the problem, call:
BISSELL Consumer Services
1-800-237-7691
Monday - Friday 8 a.m. — 10 p.m. ET
Saturday 9 a.m. — 8 p.m. ET
or visit the BISSELL website - www.bissell.com
Troubleshooting Continued
3
3
4 4
5 5
6
6
1
1
1
1
2
2
3
3
2
2
4
4
13
ug203-2829_6596_1105.indd 13ug203-2829_6596_1105.indd 13 1/11/06 4:03:41 PM1/11/06 4:03:41 PM