Filter
Top Products
5
w ww.bi sse ll .co m
Tool required: Phillips screwdriver
1. Slide upper handle onto lower handle. Insert
one screw into hole marked with an arrow
and tighten until snug.
2. Attach hose by lining up the tabs on the
collar with the corresponding notches on
the back of the vacuum as shown. Turn
clockwise to lock the hose into place.
3. Wrap the hose by routing it down and into
the lower hose clip then up and over the top
of the handle. Insert the hose wand fully into
the hose base.
Note: It is important that the hose is fully
inserted into the base for the suction air to
be directed properly to the foot during floor
vacuuming.
4. Store TurboBrush on the front of the handle
by aligning the slot at the bottom with the
tab and snapping into place.
5. Place crevice tool inside telescoping wand.
Store tools on vacuum as shown.
Assembly
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructions and
operating procedures.
1
2
4
5
Deluxe
Metal
Telescoping
Wand
Hose
Wand
Diverter
3