Filter
Top Products
www.bissell.com 800.237.7691
15
Maintenance and care
Clearing clogs
Low suction or poor pickup may be
due to a clog in the vacuum cleaner. If
you notice a change in the sound of the
motor, check for clogs.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Check the suction inlet for a clog.
5. Grasp the Quick Reach handle and lift
hose wand to separate from the suction
opening. Check for a clog in the base, the
wand or the hose.
6. Remove the screw attaching the hose
wand base to the vacuum. Straighten the
hose wand base and unclog with long,
narrow object such as a broom stick.
7. If the clog persists, follow the instructions
for checking the rotating floor brush on
page 12 and inspect the air passageway
for obstructions
Replace Headlight
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Using a flat screwdriver, table knife or
coin, insert into the slot on the right of the
lens and gently push inner latch to the left
as shown to remove the lens.
3. Reposition lens by inserting the tab on left
side and then pushing the right side back
into place.
3.
4.
5.
3.
Suction
inlet
2.