Filter
Top Products
www.bissell.com 800.237.7691
13
Maintenance and care
Replace drive belt
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. With rotating floor brush removed from
vacuum cleaner (steps 1-4 of Check rotat-
ing floor brush and drive belt), grasp old
drive belt and remove from motor pulley.
Discard old drive belt.
3. Place new drive belt over motor pulley
and stretch other end over rotating floor
brush in the space between the bristles.
4. Place ends of rotating floor brush down
into slots on sides as shown.
5. Turn rotating floor brush by hand several
times in the direction of motor pulley. If
properly installed, drive belt will center
itself on rotating brush.
6. Reposition brush cover and screw back
into place.
3.
Motor
Pulley
Motor
Pulley
4.