Filter
Top Products
9
Use BISSELL Replacement Belts (203-2519) in your
BISSELL CatchAll.
Remove the Battery Pack from the cleaner.
Turn the cleaner over and remove the two screws as
shown with a Phillips head screwdriver.
Remove both the Brush Covers by pulling up on the end
where the screw was and lift out.
Remove the Rotating Brush by grasping the Brush or the
Blade and pulling up on each end. Note the white End
Caps are removable and may come apart from the brush.
Clean strings, hair and other debris from the
Rotating Brush.
If the Belt is broken or worn, remove it and discard. Loop
new Belt over the Motor Pulley and notched area of the
Rotating Brush. Replace the End Caps and push the
Rotating Brush into the slots on the sides as shown.
Make sure the Rotating Brush is pushed all the way
down and turns freely.
Replace the Brush Covers by inserting the notched end
under the tab and pushing into place. If you have any
difficulty getting the Brush Covers into place, check again
to make sure the Rotating Brush is pushed all the way
down into the slots. You may need to rotate the End
Caps slightly to push into place. Replace the two screws
and tighten.
5.
2.
3.
1.
4.
6.
7.
Checking the Rotating Brush & Changing the Belt