Filter
Top Products
www.bissell.com 800.237.7691
11
Maintenance and care
Clearing a clog
Low suction or poor pickup may be
due to a clog in the vacuum. If you
notice a change in the sound of the
vacuum motor, check for clogs.
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Empty dirt container.
3. Check upper tank and suction inlet for clogs.
4. Grasp Quick Reach Handle and remove
hose wand from base to check for clogs
in the base, the wand, and the hose.
5. Remove the screw attaching the hose
wand base to the vacuum. Straighten the
hose wand base and unclog with long,
narrow object such as broom stick.
6. If the clog persists, follow steps for checking
rotating floor brush on page 10 and inspect
the air passageway for obstructions.
Replace headlight
1. Turn power OFF. Unplug vacuum from
electrical outlet.
2. Using a flat screwdriver or coin, insert into
the slot on the right of the lens and gently
push inner latch to the left to remove the lens.
3. Pull old bulb straight out of socket. Push new
bulb straight into socket until locked into
place.
4. Reposition lens by inserting the tab on
the left side and then pushing the right
side back into place.
TurboBrush Tool maintenance
1. Turn power OFF. Unplug vacuum cord
from electrical outlet.
2. Turn tool so bottom side faces up and
remove the two screws.
3. Remove the faceplate and clear any
obstructions
4. Remove the brush from the drive belt to
clean debris.
5. Reposition the drive belt on the brush,
and place ends of brush in slots on the
side. Reposition faceplate and
secure with two screws.
3.
Suction inlet
5.
2.
4.
2.
3.
Remove
Screw