Bissell 1720 Carpet Cleaner User Manual


 
9
1.
3.
2.
5.
WARNING:
Keep face away from
spray. Failure to do so
may result in personal
injury.
Tip:
Before turning off
Little Green, vacu-
um up clean water
to thoroughly rinse
the Vacuum Hose.
Then, lift the tool
and point upwards.
This allows any
water still in the
Hose to flow into
the Collection Tank.
3.
2.
4.
1.
4.
When You’re Done
Turn Power Switch to OFF position.
Unplug Power Cord from outlet.
Remove and rinse Solution Tank, then replace.
Note: If a significant amount of Little Green formula/water
remains, you many leave it in the Solution Tank for your next
cleaning task.
Remove Collection Tank, fill with clean water, rinse thoroughly
and discard, then replace.
Disconnect the tool from Grip/Trigger unit by pushing down on
button lock and pulling straight off (Do NOT twist tools to
remove them).
Once removed from the Vacuum/Flex Hose, the tools can
be cleaned:
4”, 6”, or Crevice tool-Rinse under clean running
water.TurboBrush tool-Switch must be in “SUCTION” posi-
tion. Rinse under clean running water.
Check Spray Nozzle for accumulated dirt or debris. If neces-
sary, clean with soft bristle brush.
Wipe all surfaces with a soft cloth.
Wrap Power Cord around Onboard Cord Storage at the bottom
of Little Green.
Wrap Vacuum Flex Hose around Onboard Hose Storage and
secure Grip/Trigger.
Store Cleaner in protected, dry area, at room temperature
(40º to 110ºF).
Note: For Little Green TurboBrush Models, on-board storage
for the TurboBrush Tool has been provided on the back of the
unit. Attach the TurboBrush to the unit by pressing onto
holder firmly until button snaps into hole.
Storage
6.
7.
BRUSH
SUCTION
TurboBrush
Cord Storage
Flex Hose