Filter
Top Products
7
Remove Vacuum Flex Hose completely from On Board
Hose Storage.
Attach 4” Tool, TurboBrush* or Crevice Tool* to Grip Trigger Unit
by pressing Tool onto Grip/Trigger Unit firmly, until button snaps
into hole. Make certain Tool is securely attached.
Unwrap Power Cord completely from On Board Cord Storage
and plug into 1230 Volt, 60 Hz grounded outlet as described in
Important Safety Instructions, page 3.
Turn Power switch to ON Position.
Note: If your LIttle Green has a built-in heater, refer to
instructions on page 7.
Press and hold Spray Trigger on Grip/Trigger unit. Spray will
start in a few seconds.
Raise the Tool slightly to check for spray. If spray does not
start, press firmly on the front of the Solution Tank while
depressing Spray Trigger.
*Optional on some Little Green models. To order optional
parts not originally included in your Little Green model,
call BISSELL Consumer Services at the telephone num-
ber listed on page 9.
Pre-treat stained or highly soiled areas: Hold the flex hose
with tool attached above carpet or upholstery, and pull trig-
ger to spray cleaning solution.
Wait 3-5 minutes before cleaning.
6.
5.
1.
2.
3.
4.
How To Deep Clean Carpet or Upholstery
Getting Ready
WARNING:
Be sure to unplug the
cord before attaching
the Turbobrush.
1.
2.
Pre-treating