Bissell 1720 Carpet Cleaner User Manual


 
Place the tool directly on soiled surface at arms length. Apply
downward pressure on the tool and pull toward you, while
pulling trigger to spray cleaning solution.
Note: If using the TurboBrush, the switch should be in the
“BRUSH” position. This activates the brush only.
Repeat, keeping the tool firmly against the surface. Continue
until no more dirt can be removed. Do not overwet.
Note: If using the Turbobrush, move the switch to the
“SUCTION” position. This activates the suction to remove the
dirt and cleaning solution. Move the switch back to the
“BRUSH” position for additional brushing action.
Do not overwet.
Release spray trigger. Vacuum area until no more cleaning
solution can be removed.
Note: If using the Turbobrush, move the switch to the
“SUCTION” position. This activates the suction to remove the
dirt and cleaning solution.
If the tool stops spraying, turn OFF Power Switch and check
cleaning solution level. Refill if needed. Never run dry.
Check the manufacturer’s tag before cleaning. “W” or “WS” on
the tag means you can use your Little Green. If tag is coded
with an “S” (with diagonal strike-through), or says “Dry Clean
Only,” do not proceed.
If manufacturer’s tag is missing or not coded, check with your
furniture dealer.
If possible, check upholstery stuffing. Colored stuffing may
bleed through fabric when wet.
8
BRUSH
SUCTION
3.
4.
1.
2.
Deep Cleaning
3.
Deep Cleaning Upholstery
1.
2.
Tip:
Check upholstery
stuffing before
cleaning.
Colored stuffing
may bleed
through fabric
when wet.
Tip:
Deep cleaning
stairs and high
traffic areas on a
regular basis can
prolong carpet
life.