Bissell 1719 Vacuum Cleaner User Manual


 
Machine storage
1. Clean exterior surface of Spot Lifter 2X with a
soft cloth dampened with water only. Do not use
a strong detergent or other cleaners as this may
damage the finish.
2. Store Spot Lifter 2X in a protected dry area, at
room temperature (40° - 110°F).
Battery removal and disposal
Note: The battery must be removed from
the Spot Lifter 2X before it is disposed of.
1. Important: Unplug charger.
2. Remove tanks (front and rear) and discard.
3. Remove screws (6) holding product housings
together.
4. Use a screwdriver to score rating label on bottom
of unit.
5. Separate housings and locate battery pack in
bottom/center of unit.
Note: If the battery is leaking, do not touch
it. Contact your local authorities for a safe
disposal or recycling facility in your area.
6. Remove wire connectors from the battery pack.
7. Keep battery packs together – DO NOT separate
individual batteries. For proper battery disposal
instructions, please contact your local authorities
for requirements and regulations on safe disposal
or recycling facilities in your area.
8. Discard remainder of product.
Maintenance and care (continued)
Screws
WARNING:
This product contains a
rechargeable nickel
cadmium battery
(sometimes referred to
as a “Ni-Cad” battery)
pack. The average life of
a Ni-Cad battery is 5 to 7
years, depending on
frequency of use. Proper
removal and disposal of
Ni-Cad batteries is required.
Do not dispose of in
the municipal waste.
Troubleshooting
Reduced Suction / No Suction
Possible Cause Remedies
1. Collection/dirty tank is full 1. Empty collection/dirty tank
2. Collection/dirty tank drain plug is loose 2. Check plug for snug fit
3. Batteries weak/undercharged 3. Recharge according to instructions
4. Collection/dirty tank not properly installed 4. Snap tank into place
9
www.bissell.com
3.
Ni-Cad
WARNING:
To reduce the risk of electric
shock, turn power switch
OFF and disconnect charger
from electrical outlet before
performing maintenance or
troubleshooting.
ug603-5419_1719E_1006.indd 9ug603-5419_1719E_1006.indd 9 10/26/06 3:37:36 PM10/26/06 3:37:36 PM