Filter
Top Products
WATE
R
FO
R
MUL
A
Charging the battery
1.
When charging for the first time, allow to charge
uninterrupted for at least 12 hours.
NOTE: When charging, the Spot Lifter 2X and
charger may become warm to the touch.
This is normal and no cause for concern.
2. Spot Lifter 2X must be in “O” (OFF) position
to charge.
3. When completely charged, your Spot Lifter 2X
will operate for up to 15 minutes. When
completely discharged, it will take approximately
12 hours to fully recharge.
4. To charge your Spot Lifter 2X, connect the round
end of the charger cord into the power port on the
back of the unit.
NOTE: Decreased operating time may
indicate that the battery has built up a
charging resistance. To recharge, first
completely exhaust the battery, recharge
it, then exhaust it once again before
recharging a second time. This procedure
may be required more than once.
Filling the solution/clean tank
1. Remove solution/clean tank by grasping it firmly
and pulling straight up.
2. Unscrew and remove the cap. Add water and
formula* to the indicated fill lines on the solution/
clean tank
*Note: Your Spot Lifter 2X includes two trial
size bottles of formula.
3. Replace cap and place solution/clean tank back
on unit.
Operations
1.
6
Formula Fill Line
Tip:
For maximum battery life, completely
discharge and recharge Spot Lifter
2X every 1-2 months.
Tip:
After unit is charged (approximately
12 hours) unplug from outlet.
This will aid in prolonging the life of
the battery.
Water Fill Line
2.
3.
6
www.bissell.com
ug603-5419_1719E_1006.indd 6ug603-5419_1719E_1006.indd 6 10/26/06 3:37:33 PM10/26/06 3:37:33 PM