Filter
Top Products
Pre-treating
1.
Turn power switch “I” (ON).
2. To pre-treat stained or highly soiled areas, hold
Spot Lifter 2X above soiled surface and press
spray trigger to spray cleaning solution.
3. Let cleaning solution set for 3-5 minutes
before cleaning.
Spot cleaning carpet
1.
Turn power switch “I” (ON).
2. Hold Spot Lifter 2X above soiled surface and press
trigger to spray cleaning solution, as in pre-treating
step 2 above.
3. Press front of Spot Lifter 2X firmly against surface
and pull toward you to remove cleaning solution
and soil.
4. Repeat steps 2 and 3 until no more dirt or cleaning
solution can be removed. Do not overwet.
5. For stubborn spots and soil, use brush to gently
scrub soiled area while continuing to spray
cleaning solution. To remove brush from unit,
gently pull on brush tab and lift out.
NOTE: If Spot Lifter 2X stops spraying,
turn power switch “
O” (OFF) and check
cleaning solution level. Refill if needed.
Never run dry.
Spot cleaning upholstery
1.
Check manufacturer’s tag before cleaning. “W”
or “WS” on the tag means you can use your Spot
Lifter 2X. If tag is coded with an “S” (with diagonal
strike-through), or says “Dry Clean Only,” do not
proceed.
2. If manufacturer’s tag is missing or not coded,
check with your furniture dealer.
NOTE: If possible, check upholstery stuffing.
Coloured stuffing may bleed through fabric
when wet.
Operations (continued)
2.
3.
5.
Tip:
Immediate attention to a spill on
upholstery can prevent permanent
staining.
Tip:
Use the brush after applying
cleaning solution and remove any
surface soil. Using the brush before
applying solution can push soil more
deeply into carpet.
Adsdfdd ghg bvh
cvbbj jkn hnbj jkvh
gcghhjj jhffhl kllgh
Manufacturer’s Tag
7
www.bissell.com
ug603-5419_1719E_1006.indd 7ug603-5419_1719E_1006.indd 7 10/26/06 3:37:34 PM10/26/06 3:37:34 PM