Filter
Top Products
Cleaning spills from hard surfaces
1. Turn power switch “I” (ON).
2. Press front of Spot Lifter 2X firmly against hard
surface to suction up spill.
3. Press spray trigger to spray cleaning solution.
4. Press front of Spot Lifter 2X firmly against hard
surface to suction cleaning solution, as in step
2 above.
NOTE: If the Spot Lifter 2X stops spraying,
turn power switch “
O” (OFF) and check
cleaning solution level. Refill if needed.
Never run dry.
Machine care
1. Turn power switch “O” (OFF).
2. Carry the Spot Lifter 2X to the sink or drain.
To empty the collection tank
1. Remove the collection/dirty tank by pressing the
tank release button at the top of the tank. The tank
will pivot out on a “hinge” at the bottom of the unit.
2. Remove the tank plug by turning approximately 1/4
turn counterclockwise and lifting out. Empty tank.
3. Thoroughly rinse the collection/dirty tank with
clean water. Be sure to rinse nozzle area.
4. Replace tank plug and turn approximately 1/4
turn clockwise, until snug.
5. To replace the tank, pivot bottom of tank back
into "hinge" and tilt up to handle. Press the tank
release button, and snap the tank into place. Test
for a secure fit before using.
NOTE: Check the solution/clean tank. If a
significant amount of formula and water
remains, you may leave it in the solution/
clean tank for your next cleaning task.
8
Operations (continued)
Maintenance and care
2.
Tip:
Check spray nozzle for accumulated
dirt or debris. If necessary, clean with
soft bristle brush.
3.
2.
3.
8
www.bissell.com
ug603-5419_1719E_1006.indd 8ug603-5419_1719E_1006.indd 8 10/26/06 3:37:35 PM10/26/06 3:37:35 PM