Filter
Top Products
9
Tip:
A special red
float device in
the tank will
cause the
cleaner to
stop removing
solution from
the carpet and
the motor sound
will rise in pitch
to let you know
the dirty water
tank is full.
The Flow Indicator
This is located on the machine base. It spins when
the trigger is pressed to indicate that the machine
is applying cleaning solution to the floor. It will
stop spinning to indicate that the SmartMix
®
Bottle or bladder needs to be refilled, or when
the trigger is released.
ReadyTools
™
Switch
This provides above floor cleaning with the
flip of a switch. Just choose the cleaning
tool, attach to the flex hose and
POWERSTEAMER
®
PROHEAT
™
PLUS is ready to clean
upholstery and more.*
* Set the switch to Floor
Cleaning when
cleaning carpets or
bare floors or set it
to Tools/PreTreat
when using the flex hose
attachments or for pre-treating floors.
* SmartTemp
™
heats the cleaning solution for
carpet and bare floor application only. It does not
heat solution sprayed through the accessory tools.
When You’re Done
1.
Disconnect the TurboBrush
™
from
the vacuum flex hose by pushing
down on the button lock and
pulling straight off.
2. Once removed from the flex hose, the
TurboBrush
™
can be cleaned:
1. Move the switch to the
“SUCTION” position.
2. Rinse under running water.
3. Check spray nozzle for dirt.
If necessary, clean with soft
bristle brush.
4. Replace TurboBrush
™
in its
special storage location on the
handle front.
Assembly
Unplug before attaching the TurboBrush.
™
Attach
TurboBrush
™
to the flex hose by pressing tool onto the
grip/trigger until button snaps into hole.
Make certain tool is securely in place.
Use
1. Move the TurboBrush
™
switch to the “BRUSH” position.
This activates the brush.
2. Place the tool directly on the soiled surface.
Apply downward pressure on the tool and
pull towards you while pulling trigger to
spray cleaning solution.
3. Release the spray trigger and move the
switch to the “SUCTION” position.
Vacuum the area until no more cleaning
solution can be removed.
4. Repeat steps 1-3 until no more dirt can be removed.
Caution: Do not overwet.
BRU
SH
SUCTION
How to use TurboBrush
™
attachment
TOOLS
PREHEAT
FLOOR
CLEANING
Flow Indicator
ReadyTools
™
Switch