Beckett CG15 Burner User Manual


 
33
CG15, CG25, CG50 Burner Manual
For the Operator
Test/Inspection Frequency Comments
Inspect area surrounding heating plant Daily Keep area clean and free of clutter
Inspect gas supply system for leaks Daily Use visual and electronic leak detection
Inspect appliance & piping for water leaks Daily Keep burner and controls dry at all times
Inspect gauges, indicators, monitors Daily Note condition. Replace defective parts
Check temperature and pressure levels Daily Compare to manufacturer’s speci cations
Make visual inspection of ame Daily Look for changes in shape, size, and color.
Monitor burner start-up Daily Verify prompt ignition and ame stability.
Monitor stack temperature Daily Compare to start-up and trend level.
Test low water cutoff and alarm Daily Follow control manufacturer’s instructions &
procedures in ASME Boiler & pressure vessel Code,
Section VI - Recommended rules for care and
operation of heating boilers.
Calculate fuel gas input ring rate Weekly Compare to appliance manufacturer’s Speci cations
Check ame safeguard sequence of
operation.
Weekly Follow control manufacturer’s instructions
Flame failure response & lockout timing. Weekly Follow control manufacturer’s instructions
Flame sensor signal level (if meter is hard-
wired)
Weekly Compare to control manufacturer’s speci cations
Main fuel gas valves Weekly Open high limit and verify cutoff operation
Inspect exhaust vent system for blockage Weekly Remove any restrictions
Inpect combustion air supply Monthly Remove any restrictions
Check high and low gas pressure interlocks Monthly Follow control manufacturer’s instructions
Check safety valves As needed Follow control manufacturer’s instructions &
procedures in ASME Boiler & Pressure Vessel Code,
Section VI - Recommended Rules for Care and
Operation of Heating Boilers.
Table 5 - Periodic Inspection Sheet
Inspect Heating System
Regularly
Lack of regular inspections and inadequate
maintenance could lead to equipment malfunction
and result in asphyxiation, explosion or re.
(Always follow the appliance manufacturer’s
recommended service instructions, when available.)
The following checklist is intended to be used
as a minimum reference guide only and does
not supersede or replace the heating appliance
manufacturer’s recommended service and
maintenance instructions or any code requirements.
Consult the installation and service instructions
provided by the individual control or component
manufacturer and carefully follow their directions.
Maintenance and testing may be required more
frequently due to dusty or severe operating conditions.
If unusual or questionable performance is observed,
shut the system down and contact your quali ed
service agency immediately.
y
y
y
y
y
Section: Maintenance and Service