Filter
Top Products
Instruction Manual – Model AFG Oil Burner
12
U.S.A.: P. O. Box 1289
•
Elyria, Ohio 44036
Canada: R. W. Beckett Canada, Ltd.
•
Unit #3, 430 Laird Road
•
Guelph, Ontario, N1G 3X7
This burner must be installed, adjusted and started only by a quali-
fied service agency
— an individual or agency, licensed and experienced
with all codes and ordinances, who is responsible for the installation and adjust-
ment of the equipment.
• Have your equipment
inspected and adjusted at least annually by
your
qualified service agency to assure continued proper operation.
• Installation and adjustment of the burner requires technical knowledge and
the use of combustion test instruments.
Do not tamper with the unit or
controls. Call your
qualified service agency.
•
Incorrect operation of the burner could result in severe per-
sonal injury, death or substantial property damage.
The following could result in fire hazard, severe personal injury, death or sub-
stantial property damage. Read carefully.
•
Never attempt to use gasoline in your heating appliance.
• Never store gasoline or combustible materials near the burner or
appliance.
•
Never attempt to burn garbage or refuse in your appliance.
• Never attempt to light the burner/appliance by throwing burning ma-
terial into the appliance.
•
Never attempt to use crankcase or waste oil or material other than the
approved fuel oils in this burner.
•
Never restrict the air inlet openings to the burner or the combustion air
ventilation openings in the room.
Printed in U.S.A. © 2001 R. W. Beckett Corporation
Owner service and maintenance
Properly installed and maintained, your AFG burner will provide years of effi-
cient, trouble-free operation. Please take care of your equipment by following the
warnings provided and by doing the following (notify your qualified service agency
if you find anything wrong):
Annually (minimum)
• Have your burner/heating appliance serviced at least annually by your quali-
fied service agency as noted above.
Daily
• Check the room in which your burner/appliance is installed. Make sure:
• air ventilation openings are clean and unobstructed
• nothing is blocking the burner inlet air openings
• no combustible materials are stored near the heating appliance
• there are no signs of oil or water leakage around the burner or appliance.
Weekly
• Check your oil tank level. Always keep your oil tank full, especially during the
summer, in order to prevent condensation of moisture on the inside surface
of the tank.
Owner’s information
Service & maintain burner
Form Number 6104BAFG R1001
Beckett warrants its equipment specifically to those who have purchased it for
resale, including your qualified service agency (dealer). In the event of any prob-
lems with your equipment or its installation, you should contact your dealer for
assistance.
Warranty
The OilHeat Manufacturers' Association supports the use of low sulfur fuels as defined by ASTM D396, Grades Number 1 Low Sulfur and Number 2 Low
Sulfur, as the preferred heating fuel for the following reasons:
• Low sulfur fuels reduce deposits on heat exchanger surfaces, extending the service interval between cleanings.
• The reduced deposits increase the efficiency of the appliance.
• Low sulfur fuels reduce particulate emissions.
• Low sulfur fuels reduce oxides of nitrogen emissions.