Aquacal 111 Heat Pump User Manual


 
32
INSTALLATION INSTRUCTIONS (continued):
Electrical Requirements -------------------------------------------43
General Requirements ------------------------------------------43
Code-Specific Requirements -----------------------------------43
Connecting External Controllers --------------------------------43
Sizing the Electrical Service ------------------------------------44
Ground Fault Protection (not recommended) ------------------44
CONTROLS CONFIGURATION & ADJUSTMENTS ----------------------45
Level-2 (dealer-service) Programming ----------------------------45
1. Entering Service Menu ---------------------------------------45
2. Time Delay ---------------------------------------------------46
3. Configuring for External Controllers -------------------------46
4. Water Sensor Calibration ------------------------------------46
5. Defrost Sensor Calibration -----------------------------------47
6. Spa Dead Band Differential (and adjustment)--------------48
7. Pool Dead Band Differential (and adjustment) -------------48
8. Changing Service Lock Code & “Back Door” Entry ----------49
Level-2 Set Up & Calibration Codes -------------------------------50
Factory Default Settings -------------------------------------------50
Troubleshooting Using Displayed Codes --------------------------51
Mode Jumper and Positioning -------------------------------------52
Defrost Systems (described and explained) ----------------------54
Water Flow Pressure Switch Adjustment--------------------------55
CONTACTING THE FACTORY ------------------------------------------57
INSTALLER-SPECIFIC TABLE of CONTENTS
(CONTINUED)