Filter
Top Products
21
Spa Heating & Spa Setback Option...
Air blowing into your spa, while it is being brought to temperature, will very often neutralize or partially
counteract the heat being put into the spa by the heater; this added heat loss equates to increased
time to bring your spa to desired temperature. When heating a spa, be sure to turn off the air blower.
Air induced through the spa jets should also be eliminated, during warm-up, whenever possible.
If your heater is being used to only heat a spa, the
POOL thermostat can be used as a setback control:
simply set the pool control at a point 10-15º F below desired spa heat temperature and select the pool
thermostat. This method allows the spa–when not in use–to be held at a heated temperature, but
somewhat lower than normal spa-use temperature. One would want to blanket the spa if using this
setback method. Using spa setback will result in reduced warm up periods over full, cold starts.
Heating Tips
Heating in Cooler Weather...
Late night and early morning, generally being the coolest times of the day, are least efficient for heat-
ing. For most efficient heating operation, heat pumps should be timed to operate during the warmest,
daylight portions of the day. Conversely, if cooling a pool, it is best to run the equipment at night. Please
set water pump and heat pump controls accordingly.
Improperly used, Pool-Spa blankets can become a drowning risk to people and pets.
Blankets are not safety covers. They are not designed to support the weight of a person
or pet. Never enter a pool until the blanket is completely removed (under no circumstances
should anyone swim under the blanket). Follow all safety recommendations of the blanket
manufacturer.
Failure to heed the following may result in permanent
injury or death.
WARNING !
MAINTENANCE
& OPERATION (continued)
A “solar” blanket will significantly reduce your heating bills. Check with the installing dealer to see if
your heat pump was sized to be used in conjunction with a blanket. Blanketed pools will typically lose
only 3 - 4° of heat per night versus 8 - 10° overnight with an un-blanketed pool. Reductions of 40-60%
on heating bills can be achieved by using blankets. (Idea...Contact AquaCal Customer Support
(800-786-7751) to learn about Liquid Blanket innovations.)
Pool/Spa Blankets...
Pool and Spa Combination Heating...
Everything stated for heating a pool applies for heating a spa—only the volume of water being heated
is different. Your heat pump comes equipped with two thermostats. One thermostat is for the pool and
the other is for the spa. Simply position the pool and spa isolation valves as directed by your installer;
select the appropriate thermostat (pool or spa), whichever you are heating, and with electrical power
and water flow supplied to the heater, the water will be maintained at set point.
Your system can be automated with the addition of an optional
External Flow Switch Kit (P.N. 0040S).
Using this option will save you from having to change the thermostat selector switch each time you
change from pool-to-spa and back again. Or, add a Universal Heater Controller (P.N. 0097TS) and
gain not only automatic thermostat switching, but also automated spa/pool water valve operation. For
details, contact the installer, the distributing dealer, or AquaCal Customer Support (800-786-7751).