Filter
Top Products
To Part Set the System
Then retire to an unprotected area
Note: Your engineer may have programmed the Part Set exit sounders as silent.
If so a single beep will be given when the exit time expires.
Unsetting the System
Your installation engineer will have defined to you what route you should take when
entering the premises with the system set. To avoid false alarms you must always
take this route.
To Unset the System
Enter
Note: If an alarm has occurred when the system was set all LEDs will be flashing
when you unset the system. Pressing the No key will display the cause of the
alarm for 3 seconds. Please refer to the Resetting After An Alarm section for
reset details.
+
or
+
or
+
For Part Set 1
For Part Set 2
For Part Set 3