Filter
Top Products
AIRSTREAM LAND YACHT GAS
TROUBLESHOOTING
PROBLEM: Water flows from both outlets, filter and unfiltered, when the filter button is pushed.
SOLUTION: No filter is installed. Install a filter.
PROBLEM: After installing a new filter, the filter life indicator still flashes red.
SOLUTION: Filter life indicator was not reset, or the attempt to reset the indicator did not work. Perform
reset sequence.
PROBLEM: Reversed Hot & Cold positions,
SOLUTION: HELPFUL HINTS: IT IS NOT NECESSARY TO SHUT OFF WATER SUPPLIES.
HANDLE SCREW REQUIRES A 7/64" HEX KEY WRENCH.
1. Remove plug button (3) from the handle by prying the button upwards from the
bottom center. If a tool is required, use something, which will not scratch the handle.
Remove set-screw (2), handle body (1), dome and pivot retainer assembly (4), cartridge
screw (5), handle adapter and handle connector assembly (6).
2. Turn cartridge stem around so that the notch is turned one half turn or 180 degrees.
3. Reinstall as follows: Be sure retainer clip (11) is present on cartridge stem and raised
edge of pivot stop (7) faces front. Note orientation of handle adapter & connector
assembly (6) in the exploded view. Completely tighten cartridge screw (5) to prevent
unwanted closure of faucet. Thread on dome clockwise until hand tight. Reinstall handle
body (1), set screw (2), and plug button (3).
PROBLEM: Faucet head is loose and water flows freely from between the head and spout.
SOLUTION: The head was not locked in place correctly. Reinstall the head and filter assembly.
PROBLEM: Slow or uneven water flow in filtered mode.
SOLUTION Filter outlet may be clogged.
1. Remove filter outlet nut, flush out carbon particles.
2. Filter cartridge may be clogged with captured contaminants. Replace filter cartridge.
If problem persists call Moen Help line at:
1-877-DRINK-H20 (1-877-374-6542)
PROBLEM: Electronic display doesn't function
SOLUTION: Replace battery.
CARE AND MAINTENANCE
All that is needed to clean your faucet is a soft damp cloth. Moen does not recommend the use of scour
pads, cleansers or chemicals. The abrasive nature of these substances could damage the faucet's finish. A
non-abrasive car wax will help to protect the finish. DO NOT SUBMERGE OR PLACE FAUCET HEAD
IN DISHWASHER.
G-15