Filter
Top Products
AIRSTREAM LAND YACHT GAS
TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone: 800-843-4741
Raising Antenna to Operating Position
Turn elevating crank in "UP" direction until some resistance to
turning is noted. Antenna is now in operating position. Check
to make sure switch on front TV jack is on.
Rotating Antenna
Make sure antenna is in "UP" position. Pull down on
directional handle with both hands until it disengages ceiling
plate and rotate for best picture and sound on television set.
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional handle aligns with
pointer on ceiling plate.
CAUTION: Antenna must be in "down" position while
traveling to prevent damage.
Turn elevating crank in the "Down" direction until resistance is
noted. Antenna is now locked in travel position.
Checking Operation
1. Tune TV receiver to nearest station and rotate antenna for
best picture and sound.
2. Turn off switch on power supply. Picture on TV receiver
should be considerably degraded with the power off.
DO'S
1. Do check parking location for obstructions before raising
antenna.
2. Do carefully raise, lower and rotate - if difficult, check for
cause.
3. Do rotate slowly when selecting station and check fine-
tuning on TV set to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
DON'TS
1. Don't force elevating crank up or down. Check for cause of trouble.
2. Don't rotate directional handle hard against stops.
3. Don't travel with lift in up position.
4. Don't leave lift part way up or down.
5. Don't apply sealing compound or paint over top of base plate or anywhere on lift.
H-14