Filter
Top Products
14
The art of purifi cation
®
IR
Control Panel details: right hand side
1. Timer: Press this button to set the timer for up to 12 hours of continuous operation. The time
left displays on the left hand side of the panel.
2. Auto: When you select auto mode, your unit will automatically change to the optimum speed
needed for air purifi cation in the room. The sensor (located on the side of the unit) will tell the
unit when to raise or lower fan speed depending on the amount of particles in the room.
Night Mode: If you wish the LCD on the left hand side of the panel to turn off , press the Auto
button and hold down for 3 or more seconds to set the panel on Sleep mode. Press Auto
button again and hold down for 3 or more seconds to turn the LCD back on.
3. Reset: Press this button after you have replaced any of the fi lters. This will reset any blinking
lights and set fi lter life to full.
Note: This function is only activated when any of the fi lters require changing. If the fi lter life is full,
the button is disabled to prevent the accidental press of the button.
4. PoWER3PEED To turn the system on, rotate knob to select a speed from 1 to 5. The light
indicator for the selected speed will display as blue and the speed you selected will display
on the left hand side of the panel. To turn the system off , rotate the knob to the “power off ”
position. When the air purifi er is turned off , the fan stops rotating.
1
2
3
4
5
15
The art of purifi cation
®
5. IR: This infrared receiver is used by your remote control to change unit settings
The default setting for the unit is moderate and will be displayed as 4 bars on the control panel.
This setting should meet most needs.
For advanced users only:
1. Make sure that the unit is on Standby mode (plug in the unit, and confi rm knob is at the
“power off ” position)
2. Press and hold “Auto” button for more than 5 seconds. You will hear a “ding” sound, the Con-
trol Setting bars will go from High, Moderate, Low, Moderate....... and then start blinking.
3. If you release “Auto “ button when “High” is blinking, the system is set to High Mode.
Answer the following questions to see if you need to change your setting.
Auto Mode: Your system will start on high to purify the air until it senses an eXTremely low con-
centration of particles and then auto change itself to the low setting.
If you answered “Yes” to any of the questions above, you may want to consider changing your
setting to “High”. If you answered “No”, answer the following question.
If you answered “Yes” to this question, you may want to consider changing your setting to “Low”.
Control Setting
Are you noticing severe indoor air pollution problems?
!REYOUORAMEMBEROFYOURFAMILYHAVINGSEVEREASTHMAANDORALLERGYISSUES
Do you want to able to always set your system to Auto* mode?
Yes No
Do you have a clean environment and purchased the unit for general air
purifi cation reasons?
Yes No