Filter
Top Products
8
ARMING WHEN STAYING HOME
Arming in the Stay mode allows you to remain home with the perimeter protection active and the interior protection off, so
that you may move freely about the premises.
1
Check the EZ Touchpad indicators.
The green
READY
light should be ON-STEADY, indicating that
the system is ready to arm.
•
If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone
number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it (close
the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).
•
If the green READY light is OFF, the optional second deadbolt is not locked. If there are two deadbolts in the system, the
other deadbolt must be locked before the system can be armed. Go to the other dead bolt location and lock it.
2
Press the STAY button.
If the deadbolt is already locked
, the
ARMED
indicator will light and
STAY
will begin to flash, indicat-
ing the 60 second exit delay period. The system will arm in the Stay mode in 60 seconds.
3
If the deadbolt is NOT locked, lock the deadbolt from the inside to arm the system.
If the deadbolt has not been locked within 60 seconds of pressing
STAY
, the system will revert
back to a disarmed state.
The STAY indicator will stop flashing and light steady, indicating the system is armed in the Stay mode.
READY
ARMED
STAY
STAY