Filter
Top Products
– 10 –
)XQFWLRQVRIWKH7RXFKSDGV
NOTE:
The functions printed directly on the keys
indicate their primary purpose (most require entry of
a security code first); the functions printed under
some keys (shown in brackets in the list below)
indicate an alternate function available on voice
touchpads only.
1.
DISPLAY WINDOW.
Custom English Display Touchpads:
2-line, 32-
character Liquid Crystal Display (LCD) touchpads
that display protection point identification, system
status, and messages.
English Display Touchpads:
Display protection
zone ID and system status messages using pre-
designated words in the LCD display.
2.
1
OFF
Disarms burglary portion of
the system,
silences alarms and audible trouble indicators,
and clears visual display after problem's
correction.
[RECORD]
Used to record up to a 2.5-minute
message.
3.
2
AWAY
Arms the entire burglary
system,
perimeter and interior.
[VOLUME]
Used with the desired
↑
[3] or
↓
[6] keys
to set playback and system announcement volume.
4.
3
STAY
Arms perimeter portion of burglary
system only. Interior protection is not armed,
allowing movement within premises without
causing an alarm.
[PLAY]
Used to playback a recorded message.
[
↑
]
Used with VOLUME key to raise volume.
5.
4
This is not a Function key. Used only as
a numeric key.
6
.
5
TEST
Tests the system and alarm sounder if
disarmed. Refer to
Testing The System
section for
test procedures.
7.
6
BYPASS
Removes individual protection zones
from being monitored by the system.
[
↓
]
Used with VOLUME key to lower volume.
8.
7
INSTANT
Arms in manner similar to the STAY
mode, but without the entry delay feature.
Entering via an entry/exit door will cause an
instant alarm.
9.
8
CODE
Used to assign additional user codes
for other users of the system.
10.
9
CHIME
Turns CHIME mode on
and off.
When on, the opening of windows or doors while
the system is disarmed will sound 3 beeps at the
touchpad(s).
11.
#
This key can be used for "Quick Arming" of
the system without use of a
security code (if programmed).
[FUNCTION]
Used to enable voice and volume
functions.
12. Key
0
[VOICE]
Used to activate the
RECORD, VOLUME, and PLAY functions.
13.
∗
READY
Used to display all open protection
zones.
[STATUS]
Used to announce system status and
faulted zones (if any exist).
14.
KEYS 0–9:
Numeric keys used to enter your
security code(s).
15.
MIC:
Microphone for Message Center recordings.
16.
MESSAGE LED:
(red). Flashes red when
message waiting or lights steady red when
recording a message.
17.
READY INDICATOR:
(green) Lit when the
system is
ready to be armed (no faults present).
While the system is disarmed, this indicator will
go on and off as protection zones are closed and
opened.
18.
ARMED INDICATOR:
(red) Lit when the
system has been armed.
19.
FUNCTION KEYS:
Keys A, B, C, D may have
been programmed for a variety of functions,
including panic (emergency) functions. For details,
see the
Function Keys
section.
20.
INTERNAL SPEAKER:
The built-in speaker
mimics the alarm sounder during alarms, and will
also "beep" during certain system functions. The
speaker also provides voice playback for any
recorded messages.