Admiral AAW-15CM1FHUE Air Conditioner User Manual


 
Your Room Air Conditioner unit is designed to
be highly efficient and save energy. Follow these
recommendations for greater efficiency.
1. Select thermostat setting that suits your
comfort needs and leave the thermostat at
that chosen setting.
2. The air filter is very efficient in removing airborne
particles. Keep the air filter clean. Typically, the filter
should be cleaned once a month. More
frequent cleaning may be necessary depending
on outdoor and indoor air quality.
3. Use drapes, curtains, or shades to keep
direct sunlight from heating your room, but
DO NOT obstruct the air conditioner. Allow air to
circulate around the unit without obstructions.
4. Start your air conditioner before outdoor
air becomes hot/cold and uncomfortable. This
avoids an initial period of discomfort while
the unit is cooling or heating off the room.
5. When outdoor temperature is cool
enough, use HIGH or LOW FAN
only. This circulates indoor air, providing
some cooling comfort, and utilizes less
electricity than when operating on a
cooling setting.
To avoid installation/operating difficulties,
read the instructions thoroughly.
NOTE: Save the shipping carton and packing
materials for future storage or transport of the unit.
Please check the contents of the hardware kit against
the corresponding model check list, prior to
installation of the unit.
See lists below.(Fig.A)
CAUTION
! !
Your Room Air Conditioner was designed
for easy installation in a single or double-hung
window. NOTE: This unit is NOT designed for
vertical (slider type) windows.
Tools Needed for Window Installation
Screw drivers: Both Philips and flat head
Power drill: 1/8 inch diameter drill bit
Pencil
Measuring tape
Scissors
Carpenters level
3/4 Screws (10)
Top Channel(1)
End Cap &
Leveling Legs(2)
Lock Washers(4)
Mounting
Brackets(2)
Angle
Brackets(2)
1-1/2 x1/4 Bolts(4)
Side Curtain RH(1)
Side Curtain LH(1)
Shutter Clamp(2)
Fig. 1A Installation Hardware Model 463AAC008BA
1/4 Screws (23)
Top Channel(1)
Seal(1)
Lock Washers(4)
1/4 Nuts(4)
Mounting
Brackets(2)
Angle
Brackets(2)
Side Curtain RH(1)
Side Curtain LH(1)
Shutter Clamp(2)
Fig. A Installation Hardware
Gasket(10)
NOTE: Surplus screw(s) for spare use.
Foam (1)
Double
Adhering
Seal(1)
Bottom Channel(1)
(F
or 15K to 24K models)
(Factory-installed)
Bottom Channel(1)
(For 8K to 12K models)
7
TIPS BEFORE INSTALLATION
WAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 9