Aarrow Fires SF 50 Stove User Manual


 
31
A check list (Pre-lighting Checks) appears in the Operating Instructions, but in addition to this the installer
should:
Operate the heating system and set the pump head.
Balance the radiators.
Re-vent and ensure no air locks.
Check the circulation round the primary system and the heat leak radiator, particularly when the
pump is running, to ensure circulation is not reversed.
Be sure that the chimney is operating and that ALL smoke and fumes are vented to the atmosphere
through the chimney terminal.
Check all joints and seals.
Clean the outside of the appliance to prevent any stains becoming burnt on.
Check the flue draught which should read 1 - 2mm, or 0.1 - 0.2mbar.
Recommended Reading:
"The Aarrow Book of the Fire".
"Wood as a Fuel" available from the Forestry Commission.
The following details must
be checked and completed by the installer at the time of the installation. Please
answer all questions as fully as possible.
Aarrow Fires Ltd cannot be held responsible for chimney or installation.
GENERAL HOT WATER SYSTEMS
1. Date visited site. / / 12. Is the boiler cross-flowed? YES / NO
2. Fuel type being used. 13. Are the pipes correctly sized? YES / NO
3. Fuel Quality (GOOD/FAIR/BAD)
4. What is the draught reading?
14. What is the calculated output
required to heat the system?
5. Is the throat plate fitted? YES / NO 15. Is a heat leak fitted ? YES / NO
6. What is the height of the flue?
7. What size is the flue?
16. What is the return water
temperature?
8. Is the flue lined? YES / NO 17. Is the pump thermostatically
controlled by a pipe stat?
YES / NO
9. Does the flue terminate above the
ridge?
YES / NO 18. What is the height and distance of
hot water tank above stove?
10. Did the installer light the fire, check
doors and adjust if necessary?
YES / NO
INSETS
11. Did the installer explain the correct
operation of the appliance?
YES / NO 19. Is there insulation around the top
of the fire and is it sealed in
correctly (in accordance with the
installation instructions)?
Please ensure that the customer understands the workings of the appliance and the associated systems.
Emphasise the danger of fumes from coal burning equipment and the necessity of regular and frequent sweeping
and cleaning of the chimney and the inside of the appliance.
Ensure that they have this copy of the Operating & Installation instructions.
Factory Final Check List
QUALITY
FINISH
PARTS
FLUE OUTLET
HOT PLATE
FUEL RETAINERS
GRATE
FIREBOX LININGS
THROAT PLATE
AIR WASH
Serial Number ………………….
THERMOSTAT
DOOR CATCHES
Assembled by……………………
INTERLOCK
ASH PAN
Checked by ……………………...
OPERATING TOOL
OPERATING INSTRUCTIONS