Filter
Top Products
13
8. DOOR ADJUSTMENTS
The catch can be adjusted by sharply tapping the catch on the inside of the door as shown in Fig 10.
Once the appliance has been under fire for a period of time the fire door may appear to have moved out of
alignment with relation to the door aperture or catch on the door interlock mechanism. This is quite normal and
due to the settling of the casing.
The fire door can be re-aligned by the user as follows:
• When the appliance is cold, open the fire door so that it is at a right angle to the front face of the fire.
• Lift the fire door up off the hinges.
• Gently tap the two hinge pins in a direction to compensate for the misalignment.
• Refit the door and check to ensure it now sits square to the body; if not repeat above steps.
Raising the door as follows:
• When the appliance is cold, open the fire door so that it is at a right angle to the front.
• Lift the fire door up off the hinges.
• Drop one washer (supplied) on the top and bottom hinge pin.
• Refit the door and check to ensure door is free of the interlock. If not remove and repeat fitting second
washer.
Figure 10
HAMMER
DOOR CATCH
KOOLER TO
TOUCH
HANDLE