Filter
Top Products
10
78-8126-0432-6-A
88 vinyl
tape
Armorcast
™
wrap
2229 mastic
tape
6.5 Apply two half-lapped layers of 4" wide 2229 tape
over applied vinyl tape in splice center. Overlap ends
of Cold Shrink jacket tubes 2" (51 mm).
6.6 Cover the applied 2229 mastic with two half lapped
layers of 88 tape.
6.7 Overwrap the entire splice with a minimum of two
half lapped layers of Armorcast
™
wrap.
Tear open the top end of the foil Armorcast material
container and fill foil container half full with water.
Squeeze the container four or five times allowing the
water to penetrate the roll. Pour out water, remove
roll from foil container and immediately apply to
splice area.
Bind the final wrap in place with vinyl tape.
Note: Wear rubber gloves provided when handling
Armorcast
™
Wrap. The resin contains a
black die that will stain human skin.
Armorcast
™
Wrap can be applied first and then
sprayed with water to activate the curing system
It will also cure from moisture in the air in
humid conditions.
6.8 Splice is complete.