Filter
Top Products
UnityOne Modular Fiber/Copper ZPHA Installation Guide V 2.1 9
The following image displays the Blank Faceplate Segment Module.
The following image displays USB ports located on the ZPHA back panel.
ZPHA Installation
When you install the ZPHA, you need the following components:
• USB cable — 1 cable for connecting to the IPS to receive power (included with device). The modular
ZPHA provides 2 USB ports (1 type A and 1 type B) on the back panel.
• RJ-45 copper network cables — 4 per segment (cables not included)
• LC-LC Simplex Multi-mode Fiber cable — 4 per segment (included with device). You should have 4
cables currently with your IPS device to connect to the ZPHA.
Figure 2 - 5: Blank Faceplate Segment Module
Figure 2 - 6: USB Ports Back Panel
Note: For Simplex Single-mode Fiber cables, contact a TippingPoint Sales
Representative.