Filter
Top Products
RFC1483
Static
Configuration
PPPoE or
PPPoA
Configuration
Voice
Configuration
Save Your
Configuration
In an RFC 1483 or an RFC 1483-MER configuration with static IP
addressing, the DHCP Client over WAN setting is disabled. You
will also see fields for local and remote WAN IP addresses, and
for the WAN IP Mask.
Assign a meaningful name to your configuration in the PVC
Name field, and record your settings here:
PVC Name: ________________ VPI: _______ VCI: _______
Local WAN IP Address: _____ . _____ . _____ . _____
Remote WAN IP Address: _____ . _____ . _____ . _____
WAN IP Mask: _____ . _____ . _____ . _____
Click the Apply button to apply your changes.
The PPPoE and PPPoA configurations require a PPP login
account with your Service Provider, in addition to VPI/VCI
numbers and IP addresses. Select the appropriate protocol from
the WAN Protocol drop-down menu.
Assign a meaningful name to your configuration in the PVC
Name field, and record your settings here:
User Name: _______________ Password: _______________
PVC Name: ________________ VPI: _______ VCI: _______
If the Service Provider uses dynamic addressing, set the Address
Selection field to Negotiate. For static addressing, set the field to
Specified and complete the fields below:
Local WAN IP Address: _____ . _____ . _____ . _____
Remote WAN IP Address: _____ . _____ . _____ . _____
WAN IP Mask: _____ . _____ . _____ . _____
Click the Apply button to apply your changes.
The Voice Configuration page contains the fields required to con-
figure the phone lines for your OfficeConnect Gateway Data and
Voice base unit. The same settings also apply to the phone ports
of the optional OfficeConnect Gateway Voice Expansion unit.
Select the appropriate Gateway from the drop-down menu, fill in
the VPI and VCI numbers, and select the Companding value as
specified by your Service Provider. Record your settings here:
Gateway: _____________ VPI: _______ VCI: _______
Click the Apply button to apply your changes.
Important: Remember to save your completed configuration using
the SaveAll button.
7